---

Page Source for DlinkDVG2001S

=begin options 

write = root 

=end options 

=head2 D-Link DVG-2001S ATA Configuration Instructions. 

Thanks to our customer Ryan for providing these instructions. 

* Plug the ATI into your router, its power supply, and a telephone 

* Unless stated otherwise, settings should be left at their defaults 

* On the same network go to http://192.168.0.80 in your web browser 

* Follow the steps in the wizard to ensure it's properly connected to
the Internet 

* On the same network go to http://192.168.0.80/admin in your web
browser 

* The username and password is admin 

* Once connected you should change your password 

* The first tab to configure is Server Configuration 

* Server FQDN: Enabled 

* Domain Name: sip2.diamondcard.us for America and Asia (or
sip.diamondcard.us for other places) 

* Outbound Proxy State: Enabled 

* Outbound Proxy Sever FQDN: Enabled 

* Outbound Proxy Domain Name: sip2.diamondcard.us or sip.diamondcard.us
as above 

* Service Domain: sip2.diamondcard.us or sip.diamondcard.us as above 

* Codec Priority & Packet Interval: Set G.711a-law to 1st, and
G.711u-law to 2nd, set the other protocols to no-use 

* Click the Apply button, ignore the message about rebooting the device
for now. 

* The second tab to configure is User Agent 

* Phone Number and Authentication Username should both be set to your
Account Id from Diamondcard, which will be shown to you on the home
page of your administration center. 

* Password will be your PIN code from Diamondcard found on the same
page as your Account ID 

* Click the Apply button 

* Go to http://192.168.0.80/ then click on the Tools tab, then the
Reboot tab. Then click the Reboot button. 

* When the device finishes rebooting you should hear a ring from your
phone, then it should work for both sending and receiving calls. 

X<sip d-link>

Tags for this page:   d-link   sip

---